Tag Archives: salt water

Duplex 2507 bolts for high strength application in salt air

Posted on November 15, 2017 by dean

Q: I have a high strength application that requires resistance to damp salt air and occasional sea splash, I’m using Monel 400 but it’s not holding up the the 75ksi of yield I need. Lots of broken bolts? Is is corrosion or  strength? Thoughts? A: Your issue isn’t the corrosion. … Continue reading →

Posted in Application, Corrosion Resistance, FAQs, High Strength, Material, Specialty Metal Fasteners, Technical Questions | Tagged , , , , , , , , , , , | Leave a comment

AL6XN vs Monel bolts for salt water and marine use

Posted on November 14, 2017 by dean

Q: Is AL6XN a steel or nickel alloy? Trying to figure out if it would perform as well as Monel in seawater. A: To answer your first question, AL6XN bolts are actually both a nickel and a steel alloy. AL6XN is often described as a high nickel content stainless alloy. Though … Continue reading →

Posted in Application, Corrosion Resistance, FAQs, Material, Specialty Metal Fasteners, Technical Questions | Tagged , , , , , , , , , , , , , , | Leave a comment

Screws for high velocity salt water with debris

Posted on July 10, 2017 by dean

Q: I have a salt water environment with high velocities and a lot of debris including sand, dirt and particles. Because of the amount of debris, I’m concerned about what material would work best. A: Both Monel and Titanium can be good choices in this situation. Both perform extremely well … Continue reading →

Posted in Application, Corrosion Resistance, Specialty Metal Fasteners | Tagged , , , , , , , , , , , , , | Leave a comment

Difference between Monel 400 and Monel K500 bolts

Posted on April 10, 2017 by dean

Q: I’m currently using Monel 400 hex head bolts in salt water. Should I be using K500? What’s the difference? A: Basically, Monel K500 is a precipitation hardened version of Monel 400. This means the material goes through a heat treating process that changes the alloy’s structural matrix to increase its tensile and … Continue reading →

Posted in Corrosion Resistance, FAQs, Specialty Metal Fasteners, Technical Questions | Tagged , , , , , | Leave a comment